Antenna Installation and Troubleshooting: A Practical Guide
Classified in Other subjects
Written at on 
English with a size of 2.77 KB.
Technical Project Documents
Technical project documents:
Memory's work is described in words.
Graphically describes the work Planos.Se
Budget.
The statement of the legal contract condiciones.Es
Antenna Mount
-By sections:
The maximum length of the mast that can be installed is 6 meters.
In poles with more than 3 meters, use a locking system with 3 struts located at 12.
The base should be anchored in the soil casing or on a concrete footing.
On each side of the tower, place fixation point rings anchored to the ground with a tensor to be adjusted to balance the tower.
After tightening the winds, install a second tower section and secure it with screws to the first joint of the sections of the tower.
When the tower gets too high, use a pole with a hook to the tower and a pulley to raise the following sections and screw them in.
As you are assembling the tower sections, move the pole and anchor it in the next leg to follow the same procedure.
To guide the string section, use a manually controlled operator.
Pivot-Based Mounts
Has a hinged folding platform anchored to the ground.
First, screw the swivel base.
Then, raise the tower by the end farthest from the base, raising it gradually as you approach the base where it is screwed.
Once you can put your foot on the 3-point fixing clamped by loops anchored in it, tighten until perfectly level.
Parabolic Antenna Settings
-Coordinate location:
This is the part of where you want to place the antenna (corresponding longitude and latitude) and the location of the satellite.
Azimuth Settings
It is the position of the plate in the horizontal plane on the north. Use a compass and a reference.
Elevation Settings
Tilt settings (in the vertical plane) in which the beam reaches the satellite signal to our dish.
Fine-Tuning
Use equipment with a field strength meter that is able to work with 2 Ghz.
-Adjust the plane of polarization.